Contact : +33 1 41 23 50 23 (9:00 – 17:00 CEST)

Type 1+2 AC surge protector single-phase

DS502E-230/G
Part Number 5022301
DS502E-230/G
  • Type 1 + 2 multipolar AC surge protector
  • Iimp total : 100 kA (10/350µs impulse)
  • Imax : 200 kA (8/20µs impulse)
  • Internal disconnections, status indicator and remote signaling
  • Conforme NF EN 61643-11, IEC 61643-11, UL1449 ed.5
Contact Us
The DS500E range of surge protectors are Type 1 + 2, very high power, they are intended to be installed at the entry of the Low Voltage installation. They are used to protect single-phase, three-phase or three-phase + Neutral networks in common mode or in common and differential mode. The 'Multi-Varistor' technology used allows the best possible behavior for the LV network (no follow-on current). The DS500E range is installed on a DIN Rail and has a double connection for the active conductor, which allows an optimized connection to the network.
SPD type
IEC

1+2
Network

230 V single-phase
AC system

TT-TN
Nominal line voltage
 Un

230 Vac
Max. AC operating voltage
Uc

255 Vac
Max. load current
if series connection
 IL

100 A
Temporary Over Voltage (TOV) Characteristics - 5 sec.
Without disconnection
 UT

335 Vac withstand
Temporary Over Voltage (TOV) Characteristics - 120 mn
Without disconnection or with safety disconnection
 UT

440 Vac disconnection
Temporary Over Voltage N/PE (TOV HT)
Without disconnection or with safety disconnection
 UT

1200 V/300A/200 ms withstand
Operating current
Continious current at Uc
 Ic

None
Follow current
If

None
Nominal discharge current
15 x 8/20 µs impulses
 In

50 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
 Imax

200 kA
Impulse current by pole
max. withstand 10/350µs by pole
 Iimp

50 kA
Total lightning current
max. total withstand @ 10/350µs
 Itotal

100 kA
Specific energy by pole
max. withstand 10/350 µs
 W/R

156 kJ/ohm
Connection mode(s)

L/N and N/PE
Protection mode(s)

Common/Differential mode
Protection level L/N
@ In (8/20µs)
 Up L/N

1.8 kV
Protection level N/PE
@ In (8/20µs)
 Up N/PE

1.5 kV
Admissible short-circuit current
 Isccr

50 000 A
Technology

MOV
SPD configuration

Single phase
Connection to Network

By screw terminals: 6-35mm² / by bus
Format

1-pole modular box assembled
Mounting

Symmetrical rail 35 mm (EN 60715)
Housing material

Thermoplastic UL94 V-0
Operating temperature
 Tu

-40/+85°C
Protection rating

IP20
Failsafe mode

Disconnection from AC network
Disconnection indicator

1 mechanical indicator by pole
Remote signaling of disconnection

Output on changeover contact
Dimensions

See diagram
Weight

1.02 kg
Standards compliance

IEC 61643-11 / EN 61643-11 / UL1449 ed.5
Certification
Thermal disconnector

Internal
Installation ground fault breaker

Type 'S' or delayed
Back-up protection device

Fuses Type gG - 500 A