Contact : 01 41 23 50 35 (9h - 17h)

Type 1+2 AC surge protector - 1-pole

Part Number: 3964
  • Type 1+2 unipolar AC surge protector
  • Iimp : 50 kA on 10/350µs impulse
  • Imax : 200 kA on 8/20µs impulse
  • Internal disconnecctions, status indicator and remote signaling
  • IEC 61643-11 and EN 61643-11

The DS500E is a SPD with a very high impulse discharge current (Iimp) of 50 kA, based on multi-varistor technology. A such high value could be required in the worse-case conditions (200 kA direct strike on installation equipped with single phase or 3-phase AC network).

SPD type 1+2
Network 230/400 V
Max. AC operating voltage Uc 440 Vac
Max. load current IL 100 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 580 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 770 Vac disconnection
Residual Current Ipe < 3 mA
Follow current If None
Nominal discharge current In 50 kA
Max. discharge current Imax 200 kA
Impulse current by pole Iimp 50 kA
Specific energy by pole W/R 625 kJ/ohm
Connection mode(s) L/N and L/PE
Protection level Up 2.2 kV
Admissible short-circuit current Isccr 50 000 A
Technology MOV
Connection to Network By screw terminals: 6-35mm²
Format 1-pole modular box
Mounting Symmetrical rail 35 mm (EN 60715)
Housing material Thermoplastic UL94 V-0
Operating temperature Tu -40/+85°C
Protection rating IP20
Failsafe mode Disconnection from AC network
Disconnection indicator 1 mechanical indicator
Remote signaling of disconnection Output on changeover contact
Dimensions See diagram
Standards compliance IEC 61643-11 / EN 61643-11
Certification EAC
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed
Fuses Fuses Type gG - 500 A