Contact : +33 1 41 23 50 23 (9:00 – 17:00 CEST)

Type 2+3 AC surge protector - Unipolar - Monobloc

DACN30VGS-10-1260
Part Number 29421032
DACN30VGS-10-1260
  • Type 2 + 3 AC surge protector
  • VG Technology
  • In: 15 kA
  • No leakage current
  • Monobloc module for each phase
  • Remote signaling
  • Optimized to TOV
  • EN 61643-11, IEC 61643-11 and UL1449 ed.5 compliance

The monobloc surge protectors Type 2+3 DACN30VG, are designed to protect AC powerline with Un=1140Vac, for wind turbines application, etc. Equipped with the exclusive CITEL’s VG technology, the range achieves an improved protection level and a total absence of leakage current, guaranteeing a maximum protection efficiency, with high capacity to withstand harmonic interference to ensure maximum lifetime. The surge protectors DACN30VG, are available in multipolar version to protect single or 3-phase networks.


SPD type
IEC

2+3

Nominal line voltage
Un

1140 Vac

Max. AC operating voltage
Uc

1260 Vac

Temporary Over Voltage (TOV) Characteristics - 5 sec.
Without disconnection
UT

1650 Vac withstand

Temporary Over Voltage (TOV) Characteristics - 120 mn
Without disconnection or with safety disconnection
UT

2200 Vac disconnection

Residual Current
Leakage current to Ground
Ipe

None

Follow current
If

None

Nominal discharge current
15 x 8/20 µs impulses
In

15 kA

Max. discharge current
max. withstand @ 8/20 µs by pole
Imax

30 kA

Withstand on Combination waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
Uoc

6 kV

Protection level
@ In (8/20µs)
Up

4.0 kV

Protection level
@ In (8/20µs) and @ 6 kV (1,2/50 µs)
Up

5.0 kV

Residual voltage at 5 kA
@ 5 kA (8/20µs)
Up-5kA

3.2 kV

Admissible short-circuit current
Isccr

25 000 A

Network type

AC

Technology

VG Technology (MOV+GSG)

SPD configuration

1-pole

Connection to Network

By screw terminals: 2.5-25mm² (35mm² rigid)

Format

Monobloc modular box

Plugable

No

Mounting

Symmetrical rail 35 mm (EN 60715)

Housing material

Thermoplastic UL94 V-0

Operating temperature
Tu

-40/+85°C

Protection rating

IP20

Failsafe mode

Disconnection from AC network

Disconnection indicator

1 mechanical indicator - Red/Green

Remote signaling of disconnection

Output on changeover contact

Wiring for remote signaling

1.5 mm² max.

Max. Voltage/Current for remote signaling

250 V / 0.5 A (AC) / 30 V / 3 A (DC)

Dimensions

See diagram - 2TE (EN43880)

Weight

0.242 kg

Standards compliance

IEC 61643-11 / EN 61643-11 / UL1449 ed.5

Thermal disconnector

Internal

Installation ground fault breaker

Type 'S' or delayed

Back-up protection device

Fuses type gG - 50 A