Contact : 01 41 23 50 35 (9h - 17h)

Type 1+2 AC surge protector - 3-phase+N

DAC1-13S-40-440
Part Number: 821710424
DAC1-13S-40-440
  • Type 1 + 2 AC multipolar surge protector
  • In : 20 kA
  • Iimp : 12.5 kA
  • Pluggable module for each phase
  • Remote signaling
  • EN 61643-11, IEC 61643-11 and UL1449 ed.5 compliance
Contact Us
The DAC1-13 is an extreme duty Type 1+2 pluggable SPD designed to protect AC powerline at the main switchboard of an installation equipped with lightning rod. The technology ‘Multi-varistor” allows a very high discharge current capability in small dimensions and the best possible behavior to the AC network (no follow current). In the light of their high discharge capability, the DAC1-13 surge protectors are especially compact and are available in multipolar versions to protect single or 3-phase AC networks.
SPD type 1+2
Network 230/400 V 3-phase+N
AC system IT
Max. AC operating voltage Uc 440 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 580 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 770 Vac disconnection
Residual Current Ipe < 1 mA
Follow current If None
Nominal discharge current In 20 kA
Max. discharge current Imax 50 kA
Total Maximum discharge current Imax Total 200 kA
Impulse current by pole Iimp 12.5 kA
Total lightning current Itotal 50 kA
Specific energy by pole W/R 40 kJ/ohm
Protection mode(s) L/PE and N/PE
Protection level L/PE Up L/PE 1.7 kV
Admissible short-circuit current Isccr 50 000 A
Network type AC
Technology MOV
SPD configuration 3-phase+Neutral
Connection to Network By screw terminals: 2.5-25mm² (35mm² rigid)
Format Plug-in modular box
Plugable Yes
Mounting Symmetrical rail 35 mm (EN 60715)
Housing material Thermoplastic UL94 V-0
Operating temperature Tu -40/+85°C
Protection rating IP20
Failsafe mode Disconnection from AC network
Disconnection indicator 1 mechanical indicator by pole - Red/Green
Spare module(s) MDAC1-13-440
Remote signaling of disconnection Output on changeover contact
Wiring for remote signaling max. 1.5 mm² single-/multi-wire
Max. Voltage/Current for remote signaling 250 V / 0.5 A (AC) / 30 V / 3 A (DC)
Dimensions See diagram - 4TE (EN43880)
Weight 0.656 kg
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 ed.5
Certification EAC
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed
Fuses Fuse assembly: SFD1-13S-40 /or 125 A min. - 315 A max. - Fuses Type gG