Contact : +33 1 41 23 50 23 (9:00 – 17:00 CEST)

Type 1+2 AC surge protector - 1-pole

DACN1-13S-10-760
Part Number 29111012
DACN1-13S-10-760
  • Type 1 + 2 AC surge protector
  • High energy discharge capacity(High duty)
  • In: 40 kA, Imax: 80kA
  • Iimp: 12.5 kA on 10/350µs impulse
  • Unpluggable module for each phase
  • Remote signaling
  • EN 61643-11, IEC 61643-11 complied

The DACN1-13S is an high duty Type 1+2 SPD designed to protect AC powerline at the main switchboard of an installation equipped with lightning rod, and in wind turbines and photovoltaic' application. Equipped with CITEL’s high energy discharge capacity technology, the range achieves an requirement on extreme high duty level, guaranteeing the possible application for high exposure location or/and high thunderstorm area, to ensure a more longer lifetime than expected. Furthermore, higher Uc(760Vac) and extreme low Up(3.5kV@40kA) bring advantage on wider range of application and higher protection efficiency for instructions.


SPD type
IEC

1+2

Max. AC operating voltage
Uc

760 Vac

Max. load current @25°C
IL

100 A

Temporary Over Voltage (TOV) Characteristics - 5 sec.
Without disconnection
UT

1000 Vac withstand

Temporary Over Voltage (TOV) Characteristics - 120 mn
Without disconnection or with safety disconnection
UT

1325 Vac disconnection

Residual Current
Leakage current to Ground
Ipe

None

Follow current
If

None

Nominal discharge current
15 x 8/20 µs impulses
In

40 kA

Max. discharge current
max. withstand @ 8/20 µs by pole
Imax

80 kA

Impulse current by pole
max. withstand 10/350µs by pole
Iimp

12.5 kA

Specific energy by pole
max. withstand 10/350 µs
W/R

40 kJ/ohm

Protection level
@ In (8/20µs)
Up

3.5 kV

Residual voltage at 5 kA
@ 5 kA (8/20µs)
Up-5kA

2.3 kV

Admissible short-circuit current
Isccr

25 000 A

Technology

MOV

SPD configuration

Single phase

Connection to Network

By screw terminals: 2.5-25mm² (35mm² rigid)

Format

1-pole modular box

Plugable

No

Mounting

Symmetrical rail 35 mm (EN 60715)

Housing material

Thermoplastic UL94 V-0

Operating temperature
Tu

-40/+85°C

Protection rating

IP20

Failsafe mode

Disconnection from AC network

Disconnection indicator

1 mechanical indicator by pole - Red/Green

Remote signaling of disconnection

Output on changeover contact

Wiring for remote signaling

1.5 mm² max.

Max. Voltage/Current for remote signaling

250 V / 0.5 A (AC) / 30 V / 3 A (DC)

Dimensions

See diagram - 2TE (EN43880)

Weight

0.390 kg

Standards compliance

EN 61643-11 / IEC 61643-11

Certification

TUV Süd

Thermal disconnector

Internal

Installation ground fault breaker

Type 'S' or delayed

Back-up protection device

Fuses Type gG - 125 A