Type 1+2+3 AC surge protector - 3-phase+N
DS254VG-300
DS254VG-300
Part Number: 3713
  • Type 1+2+3 unipolar surge protector
  • 25 kA on 10/350µs impulse
  • Low voltage Up
  • Internal disconnection, status indicator and remote signaling
  • Optimized to TOV
  • IEC 61643-11 compliance
  • UL1449 ed.4 recognition
ULCertificate_DS254VG-300.pdf Citel_Certif_UL_VZCA2_E326289.pdf Citel_Certif_UL_VZCA8_E326289.pdf

The DS250VG is an extreme duty Type 1+2+3 AC surge protector device designed to protect at the entrance of the electrical installation. This SPD is particularly useful in a high lightning density area where the risk of heavy surge current or even direct strike is high (eg: buildings equipped with lightning rods). The DS250VG is one-pole SPD and can be used in common mode or common and differential mode. DS250VG AC surge protectors are designed to be connected in multi-pole configuration to protect single-phase, 3-phase and 3-phase+Neutral AC networks, sometimes associated with a dedicated N/PE SPD.


SPD type 1+2+3
Network 230/400 V 3-phase+N
AC system TNS
Nominal line voltage Un 230/400 Vac
Max. AC operating voltage L-N Uc 255 Vac
Max. load current IL 100 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 440 Vac withstand
Residual Current Ipe None
Follow current If None
Nominal discharge current In 30 kA
Max. discharge current Imax 70 kA
Impulse current by pole Iimp 25 kA
Total lightning current Itotal 100 kA
Withstand on Combination waveform IEC 61643-11 Uoc 6 kV
Withstand on overvoltages IEEE C62.41.1 20 kV
Specific energy by pole W/R 156 kJ/ohm
Connection mode(s) L/PE and N/PE
Protection mode(s) Common mode
Residual voltage Up-in 1.1 kV
Protection level L/PE Up L/PE 1.5 kV
Admissible short-circuit current Isccr 50000 A
Technology VG
SPD configuration 3-phase+Neutral
Connection to Network By screw terminals : 6-35 mm² / by bus
Format 1-pole modular box assembled
Mounting Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe mode Disconnection
Disconnection indicator 1 mechanical indicator by pole
Remote signaling of disconnection Output on changeover contact
Dimensions See diagram
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Certification UL / EAC / TUV