Type 1+2+3 AC surge protector - 3-phase+N

DACN1-25VGS-40-760
DACN1-25VGS-40-760
Part Number: 29224012
  • Type 1 + 2+3 AC surge protector
  • VG Technology
  • In: 35 kA
  • Iimp: 25 kA on 10/350µs impulse
  • No leakage current
  • Unpluggable module for each phase
  • Remote signaling
  • Optimized to TOV
  • EN 61643-11, IEC 61643-11 complied

The DACN1-25VG is an extreme duty Type 1+2 SPD designed to protect AC powerline at the main switchboard of an installation equipped with lightning rod, and in wind turbines' application, the low-voltage side of transformer and power side of convertor is the typical application. Equipped with exclusive CITEL’s VG technology, the range achieves an high protection level, guaranteeing a maximum protection efficiency, a absence of follow and leakage currents, a simplification of use (no additional lightning arrester required) and a maximum lifetime. The DACN1-25VG surge protectors are especially available in multipolar versions to protect single or 3-phase AC 400/690Vac networks, which makes them the best surge protection solution for Type 1 requirements, and can match the temporary overvoltage or harmonic interference perfectly.


SPD type 1+2+3
Network 400/690 V 3-phase+N
Max. AC operating voltage Uc 760 Vac
Max. load current IL 100 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 1000 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 1325 Vac disconnection
Residual Current Ipe None
Follow current If None
Nominal discharge current In 35 kA
Max. discharge current Imax 70 kA
Impulse current by pole Iimp 25 kA
Total lightning current Itotal 100 kA
Withstand on Combination waveform IEC 61643-11 Uoc 6 kV
Specific energy by pole W/R 156 kJ/ohm
Protection mode(s) L/PE and N/PE
Protection level Up 2.5 kV
Protection level L/PE Up L/PE 2.5 kV
Residual voltage L/PE at 5 kA Up-5kA 1.6 kV
Admissible short-circuit current Isccr 50 000 A
Technology VG Technology (MOV+ GSG)
SPD configuration 3-phase+N
Connection to Network By screw terminals: 2.5-25 mm² (35 mm² rigid)
Format 1-pole modular box
Mounting Symmetrical rail 35 mm (DIN 60715)
Housing material Thermoplastic UL94 V-0
Operating temperature Tu -40/+85°C
Protection rating IP20
Failsafe mode Disconnection from AC network
Disconnection indicator Mechanical indicator Green/Red
Remote signaling of disconnection Output on changeover contact
Wiring for remote signaling 1.5 mm² max.
Max. Voltage/Current for remote signaling 250 V / 0.5 A (AC) / 30 V / 3 A (DC)
Dimensions See diagram - 8TE (EN43880)
Weight 1.920 kg
Standards compliance EN 61643-11 / IEC 61643-11
Certification TUV
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed
Fuses Fuse assembly: SFD1-25-40S / or Fuses Type gG 315 A