Type 1+2 AC surge protector single-phase
DS252E-120/G
Part Number: 3904
- Type 1 + 2 unipolar surge protector
- Iimp total: 50 kA (10/350µs импульс)
- Imax : 140 kA (8/20µs импульс)
- Внутренний размыкатель сети, индикатор состояния
- Дистанционная сигнализация
- Соответствуют IEC 61643-11, EN 61643-11 и UL1449 ed.3
Installation Sheet
Range Technical Sheet
The DS250E is an extreme duty Type 1+2 designed to protect the entrance of the electrical installation.
The DS250E is a one-pole SPD and can be used in common mode or common and differential mode.
DS250E AC surge protectors are designed to be connected in multi-pole configuration to protect single-phase, 3-phase and 3-phase+neutral AC networks.
This SPD is DIN rail compatible,
Select another reference:
| SPD type | 1+2 | |
| Network | 120 V single-phase | |
| AC system | TT-TN | |
| Nominal line voltage | Un | 120 Vac |
| Max. AC operating voltage L-N | Uc | 150 Vac |
| Max. load current | IL | 100 A |
| Temporary Over Voltage (TOV) Charasteristics - 5 sec. | UT | 180 Vac withstand |
| Temporary Over Voltage (TOV) Charasteristics - 120 mn | UT | 230 Vac disconnection |
| Temporary Over Voltage N/PE (TOV HT) | UT | 1200 V/300A/200 ms withstand |
| Residual Current | Ipe | None |
| Follow current | If | None |
| Nominal discharge current | In | 70 kA |
| Max. discharge current | Imax | 140 kA |
| Impulse current by pole | Iimp | 25 kA |
| Total lightning current | Itotal | 50 kA |
| Specific energy by pole | W/R | 156 kJ/ohm |
| Connection mode(s) | L/N and N/PE | |
| Protection mode(s) | Common mode | |
| Protection level L/N | Up L/N | 1 kV |
| Admissible short-circuit current | Isccr | 50000 A |
| Technology | MOV | |
| SPD configuration | Single phase | |
| Connection to Network | By screw terminals : 6-35 mm² / by bus | |
| Format | 1-pole modular box assembled | |
| Mounting | Symmetrical rail 35 mm (EN60715) | |
| Housing material | Thermoplastic UL94-V0 | |
| Operating temperature | -40/+85°C | |
| Protection rating | IP20 | |
| Failsafe mode | Disconnection | |
| Disconnection indicator | 3 mechanical indicators by pole | |
| Remote signaling of disconnection | Output on changeover contact | |
| Dimensions | See diagram |
| Standards compliance | IEC 61643-11 / EN 61643-11 / UL1449 4ed. | |
| Certification | UL / EAC / TUV |
